Cutting Vinyl Lattice With Hand Saw

To cut vinyl lattice attach a vinyl cutting blade to the power saw.

Cutting vinyl lattice with hand saw.

If you have a helper a table saw is ideal. The width depth of the blade may offer a bit more straight. Some are sold without the support spine allowing no angleing as you cut. If you don t have a vinyl cutting blade you can use another fine toothed blade.

On the other hand if you need to cut the plastic lattice into angles and curves you should use a power saber saw. Ease the saw or blade carefully through the lattice. If necessary walk on the lattice to the side of the lumber opposite the saw and marked line. Adjust the blade depth on a circular saw by releasing the blade lever on the back.

Most of the people who usually need to do it regularly suggests using a circular saw and a sharp and new cutting blade. This is the easiest way to cut vinyl lattice that i ve come across and i wanted to share it with you. Pvc lattice can be cut with a hand saw circular saw table saw or just about any saw that cuts wood. Start by cutting your vinyl lattice.

Cut correctly be sure the lattice face side is upward when a fine toothed hard saw is in use. The best saw blade for cutting vinyl lattice is one that has small straight teeth not teeth that are hooked or otherwise designed to rip and tear such as saw blades designed to cut through. Cut through the lattice joint by joint using a circular saw with a vinyl cutting blade. Remove the t square guide and the rip fence.

Have your helper assist you in guiding. I had to replace a couple vinyl lattice sections that w. Position the circular saw blade at one end of the lattice sheet lining up the blade with the marked cutting line. Hold the saw against the lattice as if you were about to cut it then let the blade dip roughly 0 5 in 1 3 cm below the level of the lattice.

A fine blade back saw much like what s used in a miter box. In case you have to do a lot of cutting in straight lines with the plastic lattice the circular saw or power saw with the plastic cutting blade is your best option. Set the blade depth 0 5 in 1 3 cm wider than the lattice s thickness. The best way to cut vinyl lattice is to use a circular saw and a cutting blade.