Cutting An Opening To Fit An Attic Ladder

Mark the sides based on your measurement and the table provided.

Cutting an opening to fit an attic ladder.

Inspect your attic space to determine the ideal location to install your ladder. Figure 1 shows the floor or ceiling joists after the access hole has been cut to install a new flight of stairs or provide an attic access. This part deals with framing the attic opening. Make sure there are no wires pipes or ducts above the ceiling near the marked cutting.

Make sure you have a space between the joists at least as large as the rough opening shown on the box and that any cut joists are attached to uncut joists. Wear safety glasses a dust mask and work gloves before you begin cutting your rough opening. Measure and mark the opening. Cutting and or removing joists to provide an entry or access can be the most difficult part of the overall project.

How to open up access into your attic space for inspection and or insulation. Cut out the opening. How to install an attic ladder step 1. Click here to purchase the easy access attic ladder by werner.

Werner provides a table telling you how much to cut off each side based on your measurement. Instead you should place the cutout opening inline with the ceiling joists rafter ties. You potentially compromise too many of the rafter cross ties by doing that. Measure the width and length of the attic access opening and compare the.

Roughing an opening for fold down attic stairs 1. Saw through the joist s being careful not to cut through the ceiling and making sure the cut ends of the joist s are flat and vertical. Covers how to select a location find studs measure and cut a hole install tr. Make sure that there are no.

Now that you ve cut your joists it s time to frame the new opening. Locate the joists in your ceiling. If the joists are installed at 16 inches on center you will need to cut one joist and attach a. I would not put the attic stairs ladder assembly opening at right angles to the ceiling joists.

Just mark the cut point on both sides of the ladder square it up with your speed square and use a hacksaw or reciprocating saw to cut the excess off. If the ceiling joists have to modified in order to make it fit properly. This way you only need to cut one of them to make the room for the rough framing opening.